Bambu Lab 3D Printer A1 Series lubricant set – Lubricant Grease *2 and Lubricant Oil *2 Brand Original

Lubricant Grease *2

Lubricant Oil *2

Introduction

First, it must be emphasized that lubricating oil and grease absolutely cannot be used on the X-axis carbon rods of the X1 and P1.

Lubricating oil is typically used for the lubrication of linear guides, slide rails, and steel shafts.

Grease, on the other hand, is used for lubricating lead screws to eliminate noise issues between belts and idler pulleys.

Theoretically, lubricating oil can also be used for lead screw lubrication, but since lubricating oil is prone to evaporation, this would require more frequent reapplication of the lubricant.

Installation

Learn more about the replacement of the filament cutter on Bambu Lab Wikihttps://wiki.bambulab.com/en/filament-acc/acc/lubricant-grease-oil